Sleeve hitch information wanted please.

[propane1]

As winter slooowwwly and gladdlly comes to and end, my Case 446 will not have anything to do, as I only have the snow caster for it. So I’m hoping to get a sleeve hitch for it so I can use my sleeve hitch attachment that I have now, on it.
So three questions at the moment.
One: what tractor number sleeve hitch will fit my tractor. Mine is a 1982 model.
Two: will 200 series tractors fit.
Three: because the 400 series tractor are higher, will the sleeve hitch attachments I have now, that work on a garden tractor with 7” or so ground clearance work on the 446 with 11” of ground clearance.

Thanks for any information you can give.

Noel

[Eugen]

Don't know about the other questions but the brinly plow I have was fine both on my 220 and the 446. Same with the tiller. I suppose there can be some minor difference but I was able to do garden work with both. then again, I'm not a purfectionist

[propane1]

Thanks Eugen.





Noel

[MattA]

The old forum had a what fits chart. Maybe we could borrow it... and maybe the chart to figure out what year your tractor is by serial number...

[DavidBarkey]

The old forum had a what fits chart. Maybe we could borrow it... and maybe the chart to figure out what year your tractor is by serial number...

@Eugen Don't we have that here ?

Dave

[Timj]

The 200s use different than the 400s. I think a H, J, or K24 is what you should be looking for.

I also think there is plans to build your own.

I don't think the implements will matter, they were made to fit a wide variety of brands of tractors.

[propane1]

The 200s use different than the 400s. I think a H, J, or K24 is what you should be looking for.

I also think there is plans to build your own.

I don't think the implements will matter, they were made to fit a wide variety of brands of tractors.

Thanks Tim.

Noel

[propane1]

Picture of the model plate.

Noel

[Timj]

The 200s use different than the 400s. I think a H, J, or K24 is what you should be looking for.

I also think there is plans to build your own.

I don't think the implements will matter, they were made to fit a wide variety of brands of tractors.

Thanks Tim.

Noel

According to this, last page, the k24 is the one for you.

Sleeve Hitch H, J, K 22 & 24 Manual 9-99726_watermarked.pdf

(881.55 KiB) Downloaded 300 times

The what fits chart wasn't totally clear. Maybe Bob @myerslawnandgarden will know for sure or what the real difference is, or if a H or J24 would work.

[propane1]

Jumpins, thanks again Tim.

Noel.