Berco blower

[Harry]

There is a Berco blower for sale locally at an excellent price. I was thinking about trying to put it on a 400 series GT. Are these set up for a certain rotation of the engine? This one is advertised that it was on a Husqvarna.

[Spike188]

Harry, I modified a burco and power it with Case tiller motor.

[MattA]

Harry I believe the MTD style and probably this berco have the correct rotation for the 400 series tractors. Before I found my Berco I was looking to adapt one to my 4016. The MTD setups normally have a belt reduction system that mounts under the tractor and then a second belt running to the blower. Basically two stages of belt reduction.

My Berco uses a chain for gear reduction on the input, 90 degree gearbox to the impeller and a shaft plus a much larger chain reduction to drive the augger.
I had this picture on put phone. I can take pictures of whatever you want.

AFAIK the Berco blower I have is designed for 18-27HP. My 16HP Vanguard engine certainly struggles to run it. It does ok in powder but in heavier snow I've got to go real easy on it. The electric joystick I have us fun but for most of the heavy wet snow I get here, I normally just use my snow caster.

[MattA]

Harry here are some pictures of a craftsman snowblower mounted to a Case 446 tractor. These were from a craigslist add a few years back.

00o0o_iWfXTjc66Pq_1200x900.jpg (74.81 KiB) Viewed 24 times

[MattA]

DSC03044.jpg (101.4 KiB) Viewed 24 times

DSC03041.jpg (79.14 KiB) Viewed 24 times

DSC03038.jpg (82.8 KiB) Viewed 24 times

DSC02909.jpg (83.19 KiB) Viewed 24 times

[MattA]

I've got more pictures of the MTD style snowblowers not mounted to tractors. I quit researching how to do this when I found my Berco. I've also got pictures of a 48" snowcaster on a 7020 run by hydraulics.