Case 448, Brantford ON, $1300

[Chad]

Not mine.

"Looking to trade for a dirt bike no China older 2 strokes etc or an atv"

https://www.facebook.com/marketplace/it ... tid=dXMIcH



Sent from my Pixel 4a using Tapatalk

[DavidBarkey]

Love to get my hands on that one . 3 pt hitch and pto as well as wheel weights . Not in the cards right now . $$$$

[Chad]

Ya my thoughts too Dave, and same scenario!

Looks to be in nice original condition (except paint) Looks like a homemade blade lifting attachment, but nice that the original attachment brackets were used and not something else all cobbled together/hacked up.

Sent from my Pixel 4a using Tapatalk

[Eugen]

oooh nice one !

[Timj]

With the exchange rate if the engine and hydraulics are good this is not too bad a price when you factor in the D-10's, 3pt, and hydraulic pto. Could be a good restoration project project, especially if you could get it a little cheaper, and end up with a workhorse.

[Spike188]

We are all thinking alike in this one. It is about 30 minutes from me. It is probably a goo0 thing work overload is keeping out of town.

[NGraham]

I sent him a message, have a KTM dual sport i'd be willing to trade, plus why start with a 220 when I could get a 448 and a couple grand haha

[Eugen]

I sent him a message, have a KTM dual sport i'd be willing to trade, plus why start with a 220 when I could get a 448 and a couple grand haha

here we go

well, I can tell you that a 3pt hitch is not easy to find and it's highly sought after, same with the hydraulic pto at the back. That tractor would push the 54" blade like crazy. I'm not saying go get it, you know best what to do. But if you go for it hope it works out! It's a very reasonable price, in my opinion.

[NGraham]

I sent him a message, have a KTM dual sport i'd be willing to trade, plus why start with a 220 when I could get a 448 and a couple grand haha

here we go

well, I can tell you that a 3pt hitch is not easy to find and it's highly sought after, same with the hydraulic pto at the back. That tractor would push the 54" blade like crazy. I'm not saying go get it, you know best what to do. But if you go for it hope it works out! It's a very reasonable price, in my opinion.

If I can finally get rid of that bike, get something bigger out of the deal, and make a couple grand, sounds like a win to me. Plus he said he has a blade for it, so no more searching for one

[Spike188]

@NGraham I wish that the pictures on cell phone were better. It looks like there might be a missing lift link and arm on the 3 point. Those are hard to fabricate. Make sure the EZ clutch is complete. Also the rear PTO lever is oriented down. That may just be a mater of rotating the mount.

If you want some pointers, stop in an look at mine before you look.