64? Case tractor C$4,700 Hamilton Ontario

[Spike188]

Spikes note: Wow, tractor frame and hood maybe pre 1973. What modifications can you find?

https://www.facebook.com/marketplace/it ... 3969584604

Case tractor C$4,700 Hamilton Ontario

[DavidBarkey]

I am not Case loader expert ,but there is a boat load of stuff that just doe not look right on this tractor .

[Eugen]

Original loader is not. But look at the size of those lift cylinders wow!

[Harry]

I have looked at this GT over and over. There obviously are some 600 series parts on it. Hood, frame rear rims and tires look like 600. Loader hydraulic valve control is not and no rear pto either. Both my 646 and 644 have rear pto on right rear fender. It does not look like a Kohler or Onan engine. Can anyone tell what the engine is? The 3 pt is not a Case, it looks cobbled together and the whole hydraulic hose situation is a mess. Harry

[DavidBarkey]

I have looked at this GT over and over. There obviously are some 600 series parts on it. Hood, frame rear rims and tires look like 600. Loader hydraulic valve control is not and no rear pto either. Both my 646 and 644 have rear pto on right rear fender. It does not look like a Kohler or Onan engine. Can anyone tell what the engine is? The 3 pt is not a Case, it looks cobbled together and the whole hydraulic hose situation is a mess. Harry

It looks to me like someone saved a 600 seiries from the scrap heap and pieced it back together with what ever could be had cheapest from PA . The loader valve is generic , cylinders are the cheapest you can buy and were probly used , the engine looks like a used air cooled single cylinder diesel (I have one ) . Who ever built it , most likely did so on a tight budget and bought most of it used . Did what ever needed doing and now painted it to try and make some money off it . As bad as it may look to us , it may very well work ok . Just needs some duct tape .