@Gordy that had to be around a 400lb roller without fluid inside. I bet that thing did a great job.
Sent from my SM-S906U using Tapatalk
the way we roll
-
Jancoe
- Posts: 326
- Joined: Sat Mar 06, 2021 3:09 pm
- Location: Houghton Lake, MI
- Has thanked: 16 times
- Been thanked: 1453 times
-
Timj
- Posts: 1457
- Joined: Thu Mar 04, 2021 9:57 pm
- Location: Central WI
- Has thanked: 5376 times
- Been thanked: 5113 times
Re: the way we roll
About thirty years ago the moles had done a number on the yard of our previous home. I threw this together out of an old water tank I had laying around.
It was crudely slapped together in a hurry. 
no bearings, just 1 1/4" pipe slipped over some 1". Used it for a while without grease but it really squawked, a few pumps of open gear lube quiets it down.
Full of water it's pretty heavy, you can feel it push going down hill but with it's size it still distributes the weight. Haven't had to use it full in quite a while. Mostly only use it empty to roll in seeding for food plots.
Tim
no bearings, just 1 1/4" pipe slipped over some 1". Used it for a while without grease but it really squawked, a few pumps of open gear lube quiets it down. Full of water it's pretty heavy, you can feel it push going down hill but with it's size it still distributes the weight. Haven't had to use it full in quite a while. Mostly only use it empty to roll in seeding for food plots.
Tim
no more mow it's time to blow 
-
Gordy
- Posts: 653
- Joined: Sat Mar 06, 2021 1:24 pm
- Location: MapleLake,MN
- Has thanked: 2343 times
- Been thanked: 2137 times
Re: the way we roll
Close
So it's raining out and bored,
I found some online calculators, pipe weight = 380.3 pounds (explains why I had to use the engine hoist to stand it up and flip it to weld the end caps on). Water volume 88 us gallons = 733.9 pounds. Pipe and water = 1,114 pounds, add to that the end caps, frame and weld wire ?
Gordy