Colt Case Ingersoll Garden Tractors

As winter slooowwwly and gladdlly comes to and end, my Case 446 will not have anything to do, as I only have the snow caster for it. So I’m hoping to get a sleeve hitch for it so I can use my sleeve hitch attachment that I have now, on it.
So three questions at the moment.
One: what tractor number sleeve hitch will fit my tractor. Mine is a 1982 model.
Two: will 200 series tractors fit.
Three: because the 400 series tractor are higher, will the sleeve hitch attachments I have now, that work on a garden tractor with 7” or so ground clearance work on the 446 with 11” of ground clearance.

Thanks for any information you can give.

Noel

Don't know about the other questions but the brinly plow I have was fine both on my 220 and the 446. Same with the tiller. I suppose there can be some minor difference but I was able to do garden work with both. then again, I'm not a purfectionist

Thanks Eugen.





Noel

The old forum had a what fits chart. Maybe we could borrow it... and maybe the chart to figure out what year your tractor is by serial number...

MattA wrote: ↑Mon Mar 07, 2022 5:29 pm The old forum had a what fits chart. Maybe we could borrow it... and maybe the chart to figure out what year your tractor is by serial number...

@Eugen Don't we have that here ?

Dave

The 200s use different than the 400s. I think a H, J, or K24 is what you should be looking for.

I also think there is plans to build your own.

I don't think the implements will matter, they were made to fit a wide variety of brands of tractors.

Timj wrote: ↑Mon Mar 07, 2022 6:24 pm The 200s use different than the 400s. I think a H, J, or K24 is what you should be looking for.

I also think there is plans to build your own.

I don't think the implements will matter, they were made to fit a wide variety of brands of tractors.

Thanks Tim.

Noel

Picture of the model plate.

Noel

Propane57 wrote: ↑Mon Mar 07, 2022 7:00 pm

Timj wrote: ↑Mon Mar 07, 2022 6:24 pm The 200s use different than the 400s. I think a H, J, or K24 is what you should be looking for.

I also think there is plans to build your own.

I don't think the implements will matter, they were made to fit a wide variety of brands of tractors.

Thanks Tim.

Noel

According to this, last page, the k24 is the one for you. The what fits chart wasn't totally clear. Maybe Bob @myerslawnandgarden will know for sure or what the real difference is, or if a H or J24 would work.

Jumpins, thanks again Tim.

Noel.