restoring pulleys
Posted: Tue Jan 18, 2022 1:14 pm
Dave
A little mill work and they are apart. Now to clean and paint the halves . Bearings , paint , 5/8"-1/2" shoulder bushing and washer all in stock on my shelves .
Dave
Colt Case Ingersoll Garden Tractors
This is a community of collectors and enthusiasts of the Colt, Case, and Ingersoll Garden Tractors
https://ccigt.com/
restoring pulleys
Page 1 of 1
Re: restoring pulleys
Posted: Tue Jan 18, 2022 2:08 pm
Niiice! They'll be like new! 
Re: restoring pulleys
Posted: Tue Jan 18, 2022 4:53 pm
Re: restoring pulleys
Posted: Wed Jan 19, 2022 12:49 pm
Everything was in stock in my shop . 0 $$ outlaid compared to over a $100
each these days up here . I prefer Frugal thanks
Dave
Re: restoring pulleys
Posted: Wed Jan 19, 2022 1:48 pm
Haha Dave, this is awesome, I was going to ask for the bearings sizes but thought I should not ask for handouts all the time, then you posted one of the sizes. 
I'll take mine apart and figure out the other size too. 
Thanks, this is very nice, not to throw out the whole thing, but just replace the bearings!!!
I'll take mine apart and figure out the other size too. Thanks, this is very nice, not to throw out the whole thing, but just replace the bearings!!!
Re: restoring pulleys
Posted: Wed Jan 19, 2022 3:01 pm
They are both the same bearing, but the flat back needs a 5/8" - 1/2" x 1/8" collar bushing and 1/8" thick washer . Or buy a stupid expensive bearing to get the 1/2" hole and collars in the flat back pulley .Eugen wrote: ↑Wed Jan 19, 2022 1:48 pm Haha Dave, this is awesome, I was going to ask for the bearings sizes but thought I should not ask for handouts all the time, then you posted one of the sizes.
Thanks, this is very nice, not to throw out the whole thing, but just replace the bearings!!!
Dave