Page 1 of 1

What do you guys think of this 4016

Posted: Sat Jul 25, 2026 1:26 pm
by MattA
I looked at this 4016 this morning. It's not perfect. It's in town and has 150hrs. What do you guys think? What's it worth?

Runs ok. Travel control is much smoother than my 4016. Hydravac works good. I did some oil on the back of the hydravac but none inside. Seemed like it was from storage with the line ends on the housing.

Usual crud underneath... has had some hydraulic lines replaced.

Seat needs repair/replacement. I heard water running in the seat when I tipped it up. The owner always stored it inside but gave it to his son who couldn't fit it in the garage or the shed which is why the owner took it back.
20260725_113926.jpg
20260725_113933.jpg
20260725_113937.jpg
20260725_114009.jpg
20260725_114033.jpg
20260725_114040.jpg
20260725_114058.jpg
20260725_114123.jpg
20260725_114140.jpg
20260725_114147.jpg
20260725_114120.jpg

Re: What do you guys think of this 4016

Posted: Sat Jul 25, 2026 1:28 pm
by MattA
Some rust under the hood plus the hood doesn't close right. Looks like the sheet metal could be bent back.
20260725_114154.jpg
20260725_114159.jpg
20260725_114235.jpg
20260725_120602.jpg
20260725_120608.jpg
20260725_120615.jpg
20260725_120627.jpg
20260725_121708.jpg

Re: What do you guys think of this 4016

Posted: Sat Jul 25, 2026 3:24 pm
by Spike188
@MattA with 150 hour that tractor is not broken in yet. I doubt that the hydravac has very many hours on it. The tractor even has rear hydraulics but not a three poit hitch. At the right price I would not hesitate. Is $2000 out of line on the high end?