Colt Case Ingersoll Garden Tractors

ISO haban sickle mower in Ontario

@Shifter123Seriously, those are hard to find anywhere. I would likely end up making one to fit . Good luck on your hunt. Maybe one will turn up.

Spike188 wrote: ↑Sun Jun 01, 2025 9:04 pm @Shifter123Seriously, those are hard to find anywhere. I would likely end up making one to fit . Good luck on your hunt. Maybe one will turn up.

Thanks good info! Did you see the 1650 cub with the 402 haban on it sell in Guelph? Someone got a good deal. 1250 for the whole package.

I did not see it. Was it on marketplace?

Spike188 wrote: ↑Sun Jun 01, 2025 9:34 pm I did not see it. Was it on marketplace?

Was on kijiji, not for very long. lol

Shifter123 wrote: ↑Sun Jun 01, 2025 8:53 pm ISO haban sickle mower in Ontario

Have one for sale, but in Northern Illinois.

Sorry,

Bob

@Shifter123 Welcome to the site . Nice to see another Canuk here . You are not that far from me . I am over in Waverley south of Midland . What Case tractors do you have ?

DavidBarkey wrote: ↑Mon Jun 02, 2025 6:03 am @Shifter123 Welcome to the site . Nice to see another Canuk here . You are not that far from me . I am over in Waverley south of Midland . What Case tractors do you have ?

Thanks! Seems to be a lot of us from the north on this one. Funny we’re so close, Only one I have right now is a 2510 case colt and a couple of cubs

Shifter welcome. Please introduce yourself in the introduction area. Just a little background info about yourself and your interest in GT’s. Harry

I have been looking for a Sickle mower since I got the 155 back in ohh 2008. So when an item showed up on Facebook Marketplace that showed part of a sickle in the picture I perked up. I messaged the seller; "Hey, how long is that sickle bar?"

And I got this picture back: And this one:
Turns out Simplicity / Allis Chalmers built a belly mower for their tractors, its not a Haban AFAIK.
Since I run a 646 loader and my son and I don't want to have to pull the belly mower to use this thing. Those mounting holes at the top right of the last photo are going to get morphed into the lower 2 points of a 3 point mount.

I have a hydraulic drive motor that will be belted to the drive pulley on the top of the whole rig. That way we can use this on my 646 3-point and also on my sons 446.

I'll document the project when I get to it.

Oh, Paid $100 for that by the way...