Colt Case Ingersoll Garden Tractors

The new to me 446 I was mistaken about the engine, its an ms not bf.

Notice in the last image, there is no adapter plate. Would the one in the technical library under the parts heading ,fit this older version plow linkage? Also, if it works would someone please indicate which holes are used in this setup. It would be very much appreciated.

Every time I walk by the tractor, I say to myself "you knew what you were doing but what were you thinking"
I keep finding the results of neglect from previous owner/owners. O well,live and learn.

I think I'll really learn about the tractor when I start repairs.

That's a good looking tractor! I'll look for the info about the plate and get back to you. True about previous owners, most tractors you get around here need work. The good news is that once you get it in shape you're good for many years.

Nice. Big plow.

Noel

Have a look at this


https://manuals.ccigt.com/Plans/C25382% ... mp-jpg.pdf


We have a manual somewhere in the technical library section that specifies which holes are for what, I'll see if I can find it.

Page 10 here

https://manuals.ccigt.com/OperatorManua ... -50843.pdf

Eugen, I saw that one in the library but my mounting bracket is different than what is shown. You can see what I mean in 2nd last image.

You have what would be called a over the top the axle lift mechanism. Someone has altered some pieces. But looks correct. This lift mechanism does not use a mid lift plate adapter. Look up the H50, H54 model as that's what you have.

Sent from my SM-S906U using Tapatalk

Kieth, you have the older style "over the axle" mount. I'm pretty sure it just mounts to the pin on the rock shaft plate like a snow blower. I think you are good.
Tim

Looks real nice, but used often means repair work to get it correct. As an example, before you work it hard you need to get the rubber grommet that seals the side of the oil filter to the tin. Without this you lose enough air flow to the exhaust valve on that side of the engine to cause problems with the valve/ seat. Any of our trusted dealers will have them, last I saw I think they were like 7-8 bucks. Cheap insurance

Here is the list of our trusted dealers,
https://manuals.ccigt.com/FAQ/Microsoft ... 0.docx.pdf


Gordy

Many thanks to all that replied.
Many more questions are bound to come up, once I really get going on it. I just noticed a botched repair weld on the bracket, and will make an attempt to rectify. My neighbor came over once after I welded new fenders on my trailer and said "looks like a strong welding job, but your last bead should be silicone".