Colt Case Ingersoll Garden Tractors

With warmer weather coming and almost out of wood close to my shop, I decided to clean up the wood furnace and give it a coat of high heat header paint. First I gave the stove pipe a light sanding and then wire brushed the furnace down good. I could have used a third can of paint but two did a good job. After the paint dried I fired up the furnace and opened the two overhead doors to get a flow of air through the shop. That paint is nasty to breathe.

Keep the Peace
Harry

Ya nasty for sure. I’d do it a second time just to get it all gone. Looks good.
Never know when could come out and give you the hehe.

Sorry Harry. Your wife is probably one of the good ones.


Noel

Propane57 wrote: ↑Wed Mar 16, 2022 8:30 pm Ya nasty for sure. I’d do it a second time just to get it all gone. Looks good.
Never know when could come out and give you the hehe.

Sorry Harry. Your wife is probably one of the good ones.


Noel

There all good ones . Some are just not good for you . My first one was not good for me , but turned out to be good for someone else. Over 25 years with the second one , so been good for me .


Dave

Propane57 wrote: ↑Wed Mar 16, 2022 8:30 pm Ya nasty for sure. I’d do it a second time just to get it all gone. Looks good.
Never know when could come out and give you the hehe.

Sorry Harry. Your wife is probably one of the good ones.


Noel

They are all good some of the time and some are good all the time. But all are not good all of the time. We all have are own peculiarities.

Keep the Peace
Harry

Yesterday I switched my tractors around to get ready for spring work outside. I moved my 446-winter tractor into the lean-to and moved the 644 lbh into the shop. I'm done working on the 446 but the 644 lbh needs some attention. The loader bucket cylinder is leaking oil and needs a seal kit, which is on the shelf ready to be installed. I also need to look at the "banana" control plate for wear. It still works fine but there is a noticeable amount of play. I'll probably change the oils while I'm at it and give it a good going over while it's in the shop.

Keep the Peace
Harry

Found some new adapters for my hoist

Dave

Wow, I hope to see seats like that in your shop! That's genius!

Once I was having a few of my friends over to enjoy some sausage on the grill and share some libations. I lifted my Snapon scissor lift up to a comfortable height and put a 4X8 sheet of plywood on it for a table.

Keep the Peace
Harry

Eugen wrote: ↑Fri Apr 15, 2022 7:48 am Wow, I hope to see seats like that in your shop! That's genius!

Just need to find some seats like that . I remember seeing new repop one some where .

Dave

I think Princess auto had those seats.


Noel