Re: Picked up the Kwik-Way loader.
Posted: Sat May 03, 2025 7:06 pm
Couple more pictures of the loader diggin. 
Noel
Noel
Colt Case Ingersoll Garden Tractors
This is a community of collectors and enthusiasts of the Colt, Case, and Ingersoll Garden Tractors
https://ccigt.com/
Picked up the Kwik-Way loader.
Page 5 of 6
Re: Picked up the Kwik-Way loader.
Posted: Sun May 04, 2025 6:04 am
That is awesome Noel . They are a great little loaders . Have fun.
Re: Picked up the Kwik-Way loader.
Posted: Sun May 04, 2025 8:39 am
Noel your sure going to enjoy this loader and saves the back too. 
Harry
HarryRe: Picked up the Kwik-Way loader.
Posted: Sun May 04, 2025 8:57 am
Yes Harry. Got plans to move two snowblowers an a 50” mowing deck, already. 
Noel
Noel
Re: Picked up the Kwik-Way loader.
Posted: Sun May 04, 2025 10:02 pm
Congratulations Noel looks like that project worked out great! Looking at the pictures it seems like that is an oversized bucket but is looks like the tractor handles it fine.
Like Harry said that is going to be one heck of a back saver!
looks like that project worked out great! Looking at the pictures it seems like that is an oversized bucket but is looks like the tractor handles it fine. Like Harry said that is going to be one heck of a back saver!
Re: Picked up the Kwik-Way loader.
Posted: Mon May 05, 2025 3:30 am
Looking at manuals, pictures and you tube videos Jeff, it looks original. It’s 40” wide. My rear tires are almost an inch wider than the bucket. Fella I got it from bought it new.
Noel
Noel
Re: Picked up the Kwik-Way loader.
Posted: Mon May 05, 2025 6:05 am
That is a OEM bucket for that loader set up . I have worked on them before . Strong little loaders , but need to watch the weight on the front axle and wheel bearings .
Re: Picked up the Kwik-Way loader.
Posted: Mon May 05, 2025 9:11 am
Yes sir Dave. That’s for sure. Thanks.
Noel
Noel
Re: Picked up the Kwik-Way loader.
Posted: Tue May 06, 2025 5:16 pm
Noel that's quite the loader on your tractor. How high does it lift? 8 feet? How's the rear end traction with the bucket full?
Re: Picked up the Kwik-Way loader.
Posted: Wed May 07, 2025 6:38 am
Hi Matt. I’d be guessing 7’ but I never measured it. Have not use it much yet. But the little I did, was not much trouble going ahead, but if your pointing down hill a little it’s a little harder to back up. As with any two wheel drive tractor, backing up hill is not there strong point. I did put my winter weight back on. Only 50 lbs, might help a little. So will be trying to figure out a weight system with out being to far out the back of the tractor.
Noel
Noel