Page 14 of 26
Re: Case 644 loader repairs
Posted: Thu Dec 22, 2022 5:10 pm
by Eugen
The engine came with a stack exhaust made of 1" iron pipe so I chose to stay with it but route it under the tractor towards the back.
https://vimeo.com/783764692
Then I took it for a spin. I can honestly say now it runs and drives.
Re: Case 644 loader repairs
Posted: Thu Dec 22, 2022 5:19 pm
by DavidBarkey
@Eugen Now you need one of these to keep up with the youngins.
Re: Case 644 loader repairs
Posted: Thu Dec 22, 2022 8:59 pm
by propane1
Those Dave, were called fart cans around here. Hehe.
Noel
Re: Case 644 loader repairs
Posted: Thu Dec 22, 2022 9:01 pm
by propane1
Eugen, you could have put a tee in there and ran duels out the back. Hehe.
Noel
Re: Case 644 loader repairs
Posted: Thu Dec 22, 2022 9:09 pm
by Timj
good progress
@Eugen 
Re: Case 644 loader repairs
Posted: Fri Dec 23, 2022 6:41 am
by DavidBarkey
propane1 wrote: ↑Thu Dec 22, 2022 8:59 pm
Those Dave, were called fart cans around here. Hehe.
Noel
Around here too . First thing I thought of when I saw the exh. going under the way like it is . Eugen is young at heart and is a good sport .
Re: Case 644 loader repairs
Posted: Fri Dec 23, 2022 6:45 am
by DavidBarkey
@Eugen that will work good and keep the noise down .How far back does it go ? Are you planning to put the back hoe on this loader ?
Re: Case 644 loader repairs
Posted: Fri Dec 23, 2022 9:43 am
by Eugen
Those fart cans are too expensive for me guys.
@DavidBarkey right now the end of the muffler reaches the axle. I'm a little worried putting the backhoe on this tractor, the rear axle are not webbed like the 600 that's factory equipped with a backhoe. It'd be nice to get that tracked device fixed.
Re: Case 644 loader repairs
Posted: Fri Dec 23, 2022 12:28 pm
by DavidBarkey
Eugen wrote: ↑Fri Dec 23, 2022 9:43 am
Those fart cans are too expensive for me guys.
@DavidBarkey right now the end of the muffler reaches the axle. I'm a little worried putting the backhoe on this tractor, the rear axle are not webbed like the 600 that's factory equipped with a backhoe. It'd be nice to get that tracked device fixed.
On that note I have a Onan NHC that I need to fix the valve seat in . Still undecided what if anything I am going to put it in . May want to extend that out and away from the driver . Heat and fume rise . But don't take my word for it , fart in the seat .
Re: Case 644 loader repairs
Posted: Sun Dec 25, 2022 9:55 am
by Eugen
Dave, the running 644 I got has the muffler going like that under and toward the back. I find it better than in front as I really dislike the smell of exhaust.
