Page 2 of 2

Re: Leaf vacuum time

Posted: Wed Nov 06, 2024 10:04 pm
by myerslawnandgarden
Toolslinger wrote: Wed Nov 06, 2024 4:06 am If I recall, the modern Trac-Vac units are wedge shapped to aid in dumping. My unit isn't, and it's that PITA process of having to pull out the packed leaves. The trailer is big enough that dumping it isn't really helpful sinve the angle is very shallow, and then it's just harder to get at the leaves to pull out.

This looks very nice in comparison.

After I hit a lotto, I have great plans for something better... Not so much for the expense, but man, I need the time to build things...

Tim - 2 loads in to leaf season so far... Managed to just clear the parking pad...
Toolslinger, you are correct. The Trac-Vac trailers are 4" wider at the back and the load of compacted leaves slides out nicely. (edited my post as each side tapers to 2" wider at the rear)

Bob

Re: Leaf vacuum time

Posted: Fri Nov 08, 2024 11:40 pm
by MattA
Would have been nice to have a Trac-Vac growing up. We had a craftsman with 42" cut and plastic bin bagger. I used to mow the neighbors lawn which would get covered in inches of oak tree leaves along the woods every week. The bagger could fill up in 20' or so. I found it was much easier to take the upper half of the bagger chute tube off and angle the lower half toward the woods. It would blow a stream of chopped leaves 20' into the woods.