A little mill work and they are apart. Now to clean and paint the halves . Bearings , paint , 5/8"-1/2" shoulder bushing and washer all in stock on my shelves .
Dave
restoring pulleys
- DavidBarkey
- Posts: 3174
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17447 times
- Been thanked: 10771 times
restoring pulleys
Dave
Dave
Mad Tractor Builder
Mad Tractor Builder
- Eugen
- Posts: 5173
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12133 times
- Been thanked: 16392 times
- Contact:
- DavidBarkey
- Posts: 3174
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17447 times
- Been thanked: 10771 times
- DavidBarkey
- Posts: 3174
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17447 times
- Been thanked: 10771 times
Re: restoring pulleys
Everything was in stock in my shop . 0 $$ outlaid compared to over a $100 each these days up here .
I prefer Frugal thanks
Dave
Dave
Mad Tractor Builder
Mad Tractor Builder
- Eugen
- Posts: 5173
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12133 times
- Been thanked: 16392 times
- Contact:
Re: restoring pulleys
Haha Dave, this is awesome, I was going to ask for the bearings sizes but thought I should not ask for handouts all the time, then you posted one of the sizes. I'll take mine apart and figure out the other size too.
Thanks, this is very nice, not to throw out the whole thing, but just replace the bearings!!!
Thanks, this is very nice, not to throw out the whole thing, but just replace the bearings!!!
Case 224, 444, 644, 680E
Kubota B26
Kubota B26
- DavidBarkey
- Posts: 3174
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17447 times
- Been thanked: 10771 times
Re: restoring pulleys
They are both the same bearing, but the flat back needs a 5/8" - 1/2" x 1/8" collar bushing and 1/8" thick washer . Or buy a stupid expensive bearing to get the 1/2" hole and collars in the flat back pulley .Eugen wrote: ↑Wed Jan 19, 2022 1:48 pm Haha Dave, this is awesome, I was going to ask for the bearings sizes but thought I should not ask for handouts all the time, then you posted one of the sizes. I'll take mine apart and figure out the other size too.
Thanks, this is very nice, not to throw out the whole thing, but just replace the bearings!!!
Dave
Dave
Mad Tractor Builder
Mad Tractor Builder