Fixing up my new 4020PS
-
Harry
- Posts: 2290
- Joined: Sun Mar 07, 2021 8:33 am
- Location: Lockport,NY
- Has thanked: 13413 times
- Been thanked: 9973 times
Re: Fixing up my new 4020PS
I’ve used the Rustoleum rust converter. It’s readily available but not sure how well it actually works.
1973 444, 1974 644, 1976 446, 1977 646, 1986 226
-
propane1
- Posts: 2900
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 6962 times
- Been thanked: 11128 times
Re: Fixing up my new 4020PS
I remember people would use lemon or orange juice on rust. The juice right out of the lemon or orange. It will turn the rust black.
Now, I’m old and can’t remember well,
, so I could be wrong. Do your research on that.
Noel.
Now, I’m old and can’t remember well,
Noel.
-
MattA
- Posts: 1305
- Joined: Sun Mar 07, 2021 1:57 pm
- Location: Swansea MA
- Has thanked: 5 times
- Been thanked: 5938 times
Re: Fixing up my new 4020PS
I picked up some rustoleum rust reformer that I can brush on. It also comes in a spray can. I also picked up some rustoleum reform and seal spray for the under side of the deck.Youtube channel "Project Farm" has a lot of good reviews including rust reformers.
Progress has been slow in the past week due to other time and energy consuming home projects. RM48 mule drive #1 was reassembled. RM48 mule drive #4 was rebuilt. RM48 mule drive #3 will be finished up tomorrow. The tensioner springs for mule drives 3, 4 & 5 (spare unit) are all stretched out and will get replaced.
RM48 deck #3 will get my relatively new set of spindles (pulleys) including the RM38 center drive. The mulching kit will go back in this deck. RM48 deck #4 will get RM48 deck #3's spindles (pulleys) since deck #4's spindles are quite rusty from being outside.
Hopefully on the list this weekend is getting the plow setup ready to sell + my weight box.
Progress has been slow in the past week due to other time and energy consuming home projects. RM48 mule drive #1 was reassembled. RM48 mule drive #4 was rebuilt. RM48 mule drive #3 will be finished up tomorrow. The tensioner springs for mule drives 3, 4 & 5 (spare unit) are all stretched out and will get replaced.
RM48 deck #3 will get my relatively new set of spindles (pulleys) including the RM38 center drive. The mulching kit will go back in this deck. RM48 deck #4 will get RM48 deck #3's spindles (pulleys) since deck #4's spindles are quite rusty from being outside.
Hopefully on the list this weekend is getting the plow setup ready to sell + my weight box.
Ingersoll 4016