Colt Case Ingersoll Garden Tractors

Has anyone seen this before?

keith wrote: ↑Wed May 17, 2023 7:43 am Has anyone seen this before?

See what?

keith wrote: ↑Wed May 17, 2023 7:43 am Has anyone seen this before?

something didn't load

Image now loaded, for the sorry for the delay.

keith wrote: ↑Wed May 17, 2023 7:43 am Has anyone seen this before?DSCF0722.JPG

I have worked on a few Onans . but never seen that . I suspect the cage failed jamming the ball .
@keith
I have a good cam shaft Assembly you can have . You just need to figuer out shipping or if someone can pick it up for you .

I'm rebuilding an emerald 1 generator engine for my 446 and it has nylon/plastic retainer/cage for the fly balls. Should I use this or change it to the metal one?

keith wrote: ↑Wed May 17, 2023 8:13 am I'm rebuilding an emerald 1 generator engine for my 446 and it has nylon/plastic retainer/cage for the fly balls. Should I use this or change it to the metal one?

I used the the nylon out the genny engine for mine , but it had only 50 hrs on it . Bommer is the one to ask that question I would think . Nylon is know to get brittle with age . That being said , how many hours on it .?

Not sure of how many hours on the engine, more than yours but just needs a hone to freshen it up.

@keith If you have not already . read this . I have done a couple of these with great success .
onan genny engine rework

I have read your posts and am thankful for you and everyone else for doing so with pics that helps guys like me that have very little knowledge of mechanics.