The doors work great, but the mud slick right outside the doors isn't as great. I need to pour concrete out there. And it's down in a low spot, so I need to install a drain grate across the doorway width, so any water that rolls down in there can drain away. Then I intend to pour a 10' by 8' slab, just to kind of give me a hard surface approach to the shop.
First step is clearing the old doorway slab. It's 4'x4'x4", which means it weighs right around 800 lbs. I cut it and slid it aobut 10inches away from the building in the original phase of the project. That took well over an hour and a landscaping bar and a J bar and a gallon of sweat.
Enter the new loader forks, and no sweat was broken. 8 minutes and it was all moved. It would have been 5 minutes, but I got stuck trying to drive up the little slope to the final spot. The smooth turf tires were just happily spinning. So I loaded a couple 50lb sandbags on the cournterweight and then stood back there and it grudgingly eased up the hill. I'm okay with it, carrying 800lb slabs up grass hills with no tire chains shouldn't really be possible in my original design specs. So I'm pleased that it did it at all.
Bob
