h44 deck spindles
Posted: Sat May 28, 2022 3:29 pm
The answer is, "Yes, it'll take right around 16 and 1/2 tons of force." And, "yes it will."
The question is, "If you don't know what you're doing, and you try to press the bearing stack straight up from the bottom out of a mower deck spindle, can you just push the whole stack out of the housing without removing the c-clips? If you do, will it chowder up the groove that the clip rides in?"
Ugh.
Now I have to put a little weld bead in there and mount it in e lathe and clean that groove back up.
Bob
The question is, "If you don't know what you're doing, and you try to press the bearing stack straight up from the bottom out of a mower deck spindle, can you just push the whole stack out of the housing without removing the c-clips? If you do, will it chowder up the groove that the clip rides in?"
Ugh.
Now I have to put a little weld bead in there and mount it in e lathe and clean that groove back up.
Bob