In one of my parts buying deals I ended up with this 15hp horizontal shift clone of an engine, basically new starts at first key. The po was going to use it to repower a 444. I find myself not knowing what to do with it. Originally I was going to use it to build a loader on that 444. Now that my loader itch has been addressed by the 644...
What to do with this
-
- Posts: 5247
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12680 times
- Been thanked: 16763 times
- Contact:
- thebuildist
- Posts: 844
- Joined: Mon Jul 26, 2021 5:09 pm
- Location: Atlanta, ga
- Has thanked: 860 times
- Been thanked: 3416 times
Re: What to do with this
That's simple!
My home shipping address is.....
My home shipping address is.....
"Never be afraid to try something new. How hard can it be?"
-
- Posts: 5247
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12680 times
- Been thanked: 16763 times
- Contact:
- DavidBarkey
- Posts: 3360
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 18393 times
- Been thanked: 11659 times
Re: What to do with this
Versatile little engines . I have a 13 hp on a dump tractor I built . Hooking up remote throttle and choke cables were a pain though. But it works good .
Dave
Dave
Dave
Mad Tractor Builder
Mad Tractor Builder
- Gordy
- Posts: 653
- Joined: Sat Mar 06, 2021 1:24 pm
- Location: MapleLake,MN
- Has thanked: 2343 times
- Been thanked: 2136 times
Re: What to do with this
Last week I saw a youtube video for a home made stump grinder. Then there was one for a homemade chipper/shredder
Gordy
Gordy
- Harry
- Posts: 1739
- Joined: Sun Mar 07, 2021 8:33 am
- Location: Lockport,NY
- Has thanked: 10489 times
- Been thanked: 7444 times
Re: What to do with this
I have a stump grinder that has a 13hp Honda engine on it. It works very well it just takes some time to grind deep enough. I've used this a lot over the last ten years and have been careful not to hit any rocks that tear up the carbides.
Keep the Peace
Harry
Keep the Peace
Harry
1973 444, 1974 644, 1976 446, 1977 646, 1986 226
-
- Posts: 5247
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12680 times
- Been thanked: 16763 times
- Contact:
Re: What to do with this
A stump grinder would probably be the most useful thing for me. Will have to look into getting carbides for the cutting wheel.
- Harry
- Posts: 1739
- Joined: Sun Mar 07, 2021 8:33 am
- Location: Lockport,NY
- Has thanked: 10489 times
- Been thanked: 7444 times
Re: What to do with this
I did have one break off. I silver brazed in it's place a piece of a carbide cutting tool.
Keep the Peace
Harry
Keep the Peace
Harry
1973 444, 1974 644, 1976 446, 1977 646, 1986 226