50 hours in almost two years.
- propane1
- Posts: 2451
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 5820 times
- Been thanked: 8812 times
Re: 50 hours in almost two years.
I’ve been doing that, writing on the sleeve what it fits. And I wrap tape around the belt and put the length on it. Of course today, I need a 84”. I’ve got a 83, a few 82’s, 79, 78, and others. Jumpins.
- Eugen
- Posts: 5166
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12103 times
- Been thanked: 16346 times
- Contact:
Re: 50 hours in almost two years.
I need to do something like that because every time I need to put the deck or snowcaster on I must try at least three different belts before I find the right one.JSinMO wrote: ↑Mon Jul 25, 2022 9:46 pm Your supplier is probably better than what we have around here. Your pretty much on your own to get the size you need. Which would be fine except I always seem to find a way to pick the wrong one!
I try to keep extra belts around too, but naturally when I need one I don’t have the right size! I stared keeping the cardboard sleeve the belts come in and write on it what it fits. Next time I need on I can look at that and know what size I need.
Case 224, 444, 644, 680E
Kubota B26
Kubota B26
- Eugen
- Posts: 5166
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12103 times
- Been thanked: 16346 times
- Contact:
Re: 50 hours in almost two years.
Great idea with the tape! I'll do that from now on. I'll use painter tape.
Case 224, 444, 644, 680E
Kubota B26
Kubota B26
- DavidBarkey
- Posts: 3147
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17303 times
- Been thanked: 10644 times
Re: 50 hours in almost two years.
I keep the sleeves as well . On customers tractors I know I will service again I write the belt sizes on the bottom of the hood . The tape trick I learned for my belt supplier . There are two ways to measure a belt from the center line how it runs on the pulleys (letter for width and length in "s ,but you need the measuring tool for that . Or the width and length around the out side ( Outside Circumference ) in "s .
Dave
Mad Tractor Builder
Mad Tractor Builder