I got some thing to do. !!!!
- propane1
- Posts: 2451
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 5820 times
- Been thanked: 8812 times
Re: I got some thing to do. !!!!
Well the rain stopped and got at the wood again. None from the neighbour's this time. Useing my own wood I have against the garage. Only a short distance to go, outside to inside on same wall. I could load up an arm load and do it that way, but using the loader is easier on my back and it might be faster. But burning the expensive fuel doing it.
Noel
Noel
- Eugen
- Posts: 5166
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12103 times
- Been thanked: 16346 times
- Contact:
Re: I got some thing to do. !!!!
Time to convert the little tractor to steam Noel!!! You have enough wood to make it run for a long time!
Case 224, 444, 644, 680E
Kubota B26
Kubota B26
- propane1
- Posts: 2451
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 5820 times
- Been thanked: 8812 times
Re: I got some thing to do. !!!!
There. One more row to finish. Maybe today, maybe not. The FBH or the BFH, which ever way you want to call it, helps to get the pieces in at the top.
Wood gasifire tractor Eugen ? I think that’s what it called. There was a lot of wood gas vehicles in the Second World War. Tanks, tractors and stuff.
Noel
Wood gasifire tractor Eugen ? I think that’s what it called. There was a lot of wood gas vehicles in the Second World War. Tanks, tractors and stuff.
Noel
- propane1
- Posts: 2451
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 5820 times
- Been thanked: 8812 times
- DavidBarkey
- Posts: 3147
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17303 times
- Been thanked: 10644 times
Re: I got some thing to do. !!!!
Noel , Impressive what that little Massey can lift with that much of a reach . I see it is a tip bucket , but can't make out what lift the boom .
Dave
Dave
Dave
Mad Tractor Builder
Mad Tractor Builder
- thebuildist
- Posts: 818
- Joined: Mon Jul 26, 2021 5:09 pm
- Location: Atlanta, ga
- Has thanked: 839 times
- Been thanked: 3270 times
Re: I got some thing to do. !!!!
That thing is ingenious for its simplicity!
A single small hydro cylinder driving that whole thing. Crazy. I love it.
A single small hydro cylinder driving that whole thing. Crazy. I love it.
"Never be afraid to try something new. How hard can it be?"
- propane1
- Posts: 2451
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 5820 times
- Been thanked: 8812 times
Re: I got some thing to do. !!!!
Well Dave, it can only lift about 30 lbs. there is a winch at the front that pulls down on that arm behind the pivot point. If I had the pivot point out from the tractor more, it would lift more. So what you see in the bucket is I’m guessing 60 lbs of wood. So I just leave the bucket up and fill it. And the winch can hold it. When I made it, I tryed to make it look like a model 38 pipe loader you would see on a MF 135 tractor. And when I built it, it was many for parades and displays. But of course I had to start useing it.
It has been a wonderful attachment. I’ve used it a lot in the past ten years or so. You name it, it’s probably been in it. My portable wheelbarrow.
Bob, not a hydraulic cylinder, wish it was. It’s a 1500 winch from Canadian tire in there.
Have had a lot of comments on it over the years. I built a manure spreader to haul behind it at shows. Made out of wood. Beaters are ground driven. Just for shows. It doesn't throw. I would put fake manure, black earth, peat moss , and long grass in the spreader for looks. Then throw it at people I knew going along the parade route. Use to have a lot of fun with the stuff.
That’s quite a ramble. Have a good day gentlemen.
Noel.
Mf14 hauling it in this picture. The MF 12 has the loader and manure bucket.
It has been a wonderful attachment. I’ve used it a lot in the past ten years or so. You name it, it’s probably been in it. My portable wheelbarrow.
Bob, not a hydraulic cylinder, wish it was. It’s a 1500 winch from Canadian tire in there.
Have had a lot of comments on it over the years. I built a manure spreader to haul behind it at shows. Made out of wood. Beaters are ground driven. Just for shows. It doesn't throw. I would put fake manure, black earth, peat moss , and long grass in the spreader for looks. Then throw it at people I knew going along the parade route. Use to have a lot of fun with the stuff.
That’s quite a ramble. Have a good day gentlemen.
Noel.
Mf14 hauling it in this picture. The MF 12 has the loader and manure bucket.
- Eugen
- Posts: 5166
- Joined: Wed Mar 03, 2021 2:52 pm
- Location: Port Mcnicoll, Ontario
- Has thanked: 12103 times
- Been thanked: 16346 times
- Contact:
Re: I got some thing to do. !!!!
Great ingenuity Noel, well deserved award! Both the loader and the spreader are awesome!
Case 224, 444, 644, 680E
Kubota B26
Kubota B26
- DavidBarkey
- Posts: 3147
- Joined: Sat Mar 06, 2021 10:35 am
- Location: Waverley On.
- Has thanked: 17303 times
- Been thanked: 10644 times
Re: I got some thing to do. !!!!
@Propane57 Noel , where did you get the plans for the spreader ?
Dave
Dave
Dave
Mad Tractor Builder
Mad Tractor Builder
- propane1
- Posts: 2451
- Joined: Thu Dec 23, 2021 11:32 am
- Location: PEI, Canada
- Has thanked: 5820 times
- Been thanked: 8812 times
Re: I got some thing to do. !!!!
Hehe. In me head Dave.
But really, I just looked at a manure spread form a distance quite a few times as I drove by. Then one day drove in to get a close up look. And Jumpins it was a MF 110 manure spreader. Any way just got a good look at it. No phones then to take pictures.
And a toy manure MH spreader. Then I got at it. All painted by me. Even the decal part.
I might hook it to the Case 446 and put it in the Dundas Plow Match parade, like I did in 2019.
Noel
But really, I just looked at a manure spread form a distance quite a few times as I drove by. Then one day drove in to get a close up look. And Jumpins it was a MF 110 manure spreader. Any way just got a good look at it. No phones then to take pictures.
And a toy manure MH spreader. Then I got at it. All painted by me. Even the decal part.
I might hook it to the Case 446 and put it in the Dundas Plow Match parade, like I did in 2019.
Noel