Battery Desulfators

[MattA]

Anybody had any luck with using Battery Desulfators to remove the sulfate from lead acid battery plates?

[DavidBarkey]

Anybody had any luck with using Battery Desulfators to remove the sulfate from lead acid battery plates?

I have not tried one yet but seen a lot of nonpartisan support from many fields especially in deep cycle batteries ie. solar battery banks .

Dave

[propane1]

Never knew there was such a thing. Interesting.


Noel

[DavidBarkey]

Never knew there was such a thing. Interesting.


Noel

The basic princible is it pulses the charge in stead of being slow and steady . Theory is that this dislodges the sulphate crystals build up on the plates and allows it to be reabsorbed into the acid again .

Dave

[Harry]

The battery maintainer that I have is supposed to pulse according to the directions, but have no idea when it pulses. https://www.amazon.com/Clore-Automotive ... 91&sr=8-31

Keep the Peace
Harry

[propane1]

Oh. I have a little Canadian Tire battery charger that does that, maybe. It’s a 2 or 12 amp charger. I guess it’s the same thing. It comes on and charges to a certain voltage, then shuts down, once the voltage drops a bit, it comes back on. Saved a lot of batteries with it. Thanks Dave.


Noel

[DavidBarkey]

The battery maintainer that I have is supposed to pulse according to the directions, but have no idea when it pulses. https://www.amazon.com/Clore-Automotive ... 91&sr=8-31

Keep the Peace
Harry

image.png

During the charging process Harry .

Dave

[Eugen]

I once built the widow maker version just for the fun of doing it. Line voltage, big capacitor, power resistor, large spikes of voltage smashing the sulfation, they say. Never seemed to do a thing. Then I asked myself, do I really know the battery needs desulfation? Maybe it has a different problem. It's still in a box somewhere.

[Eugen]

The battery maintainer that I have is supposed to pulse according to the directions, but have no idea when it pulses. https://www.amazon.com/Clore-Automotive ... 91&sr=8-31

Keep the Peace
Harry

image.png

During the charging process Harry .

Dave

I suspect it has a pulsing mode separate from just charging?

[Harry]

I check it daily just to make sure it's still operating. I have it hooked up to four batteries in four tractors. I can see by looking at the face of the charger that a green light goes on then off for the four different indicators on the charger. If that means it's charging or pulsing I'm not sure. I've checked the batteries in the tractors by removing the alligator clips and testing with my multi meter. They all have been holding at 13 volts. When I moved my 644 lbh into the shop it started right up after setting since Christmas. I put my 446 snow caster tractor into the lean-to and hooked that battery up to the battery maintainer.

Keep the Peace
Harry