Shop lights

Tools, fabrication, measuring, storing...
User avatar
MattA United States of America
Posts: 859
Joined: Sun Mar 07, 2021 1:57 pm
Location: Swansea MA
Has thanked: 2 times
Been thanked: 3586 times

Re: Shop lights

Post by MattA »

FUTZ wrote: Mon Jan 30, 2023 7:27 pm
Gordy wrote: Sat Jan 28, 2023 10:32 pm

The heat can only move so far when the heat sink is surrounded by plastic with no vent holes.

:cheers:
Gordy
Actually the cup that the board is sitting on is some kind of heat dissipater. I drilled through to make a vent and saw that there was an aluminum lamination.
The board is likely secured to the base with a thermally conductive adhesive. The base is the heatsink. The LED bulb will cool better in an open lamp vs a closed fixture.
Ingersoll 4016
User avatar
Gordy United States of America
Posts: 653
Joined: Sat Mar 06, 2021 1:24 pm
Location: MapleLake,MN
Has thanked: 2343 times
Been thanked: 2136 times

Re: Shop lights

Post by Gordy »

FUTZ wrote: Mon Jan 30, 2023 7:27 pm
Gordy wrote: Sat Jan 28, 2023 10:32 pm

The heat can only move so far when the heat sink is surrounded by plastic with no vent holes.

:cheers:
Gordy
Actually the cup that the board is sitting on is some kind of heat dissipater. I drilled through to make a vent and saw that there was an aluminum lamination.
I noticed that on mine too. And I know plastic is not a good insulator, but it is a better insulator than bare aluminum. One LED in the bathroom just started flickering as the others did, so it is not long for this world :headbash:

:cheers:
Gordy
Post Reply