Search found 890 matches
- Tue May 07, 2024 7:32 am
- Forum: Vanguard
- Topic: Vanguard 12.5HP/14HP/16HP/18HP carburetor cleaning
- Replies: 27
- Views: 32632
Re: Vanguard 12.5HP/14HP/16HP/18HP carburetor cleaning
@ the one on the left in the first pic is looking lean . I read somewhere that the Kohler and B&S twins have a lean bank and that the jet on one side is a half size larger and not to get them mixed up when redoing the 2 barrel carbs . Yes the 21HP and 23HP engines had 2 barrel carbs with two di...
- Mon May 06, 2024 9:47 pm
- Forum: Vanguard
- Topic: Vanguard 12.5HP/14HP/16HP/18HP carburetor cleaning
- Replies: 27
- Views: 32632
Re: Vanguard 12.5HP/14HP/16HP/18HP carburetor cleaning
Matt , did you ever check your float height ? If too low it will also cause to run lean . Have you checked compression ? Have you tried a different set of spark plugs ? I know they are long life but that doesn't mean they can't go bad . Spark plug colour . What does it say ? Maybe more than one thi...
- Mon May 06, 2024 7:10 pm
- Forum: Everything Else
- Topic: Pictures: this moment
- Replies: 1054
- Views: 711164
- Sun May 05, 2024 9:58 pm
- Forum: Vanguard
- Topic: Vanguard 12.5HP/14HP/16HP/18HP carburetor cleaning
- Replies: 27
- Views: 32632
Re: Vanguard 12.5HP/14HP/16HP/18HP carburetor cleaning
I replaced the carb gasket this week and also shot some carb cleaner through the various holes in the carb while I had it apart. The pilot jet was nice and clean. Still lacks power. I tried adjusting the carb a bit. I left it a tad richer. Towards the end of the carb adjstment procedure, there is a ...
- Sun May 05, 2024 9:35 pm
- Forum: Everything Else
- Topic: Pictures: this moment
- Replies: 1054
- Views: 711164
- Sun May 05, 2024 8:19 pm
- Forum: Case Colt Ingersoll Discussion
- Topic: Painting hood on 444
- Replies: 16
- Views: 2021
Re: Painting hood on 444
Sorry to see the paint job ruined. This is what I used to paint my deck 7 years ago. Looked great but the paints been flaking down to the metal for years especially when I wash the deck with the hose set to stream. Maybe the rustoleum primer is also crap? I wiped the deck down with isopropyl alcohol...
- Sun May 05, 2024 5:08 pm
- Forum: Everything Else
- Topic: Pictures: this moment
- Replies: 1054
- Views: 711164
Re: Pictures: this moment
Bought it :thumbsup: At some point I'll start work on a mount to the mule drive. Both linear actuators work. The bucket dump actuator has a clutch when it hits the end of its range. The lift probably does but I can't test that without the actuator mounted on both ends. The bucket is actually small e...
- Sun May 05, 2024 8:16 am
- Forum: Case Colt Ingersoll Discussion
- Topic: 444 deal or no deal
- Replies: 13
- Views: 606
Re: 444 deal or no deal
IMO you can do a lot better for $200.
- Tue Apr 30, 2024 11:05 pm
- Forum: Everything Else
- Topic: Birth announcement
- Replies: 14
- Views: 585
Re: Birth announcement
Congrads Eugen
- Mon Apr 29, 2024 7:58 am
- Forum: Engines
- Topic: Oil Filter Examination
- Replies: 4
- Views: 547
Re: Oil Filter Examination
Is the material magnetic ? or not David the larger flakes were magnetic. The magnet had trouble picking up the very small pieces. Not sure if the small pieces are aluminum or just embedded into the filter media. Magnet material could be pretty much anything but the engine block. I did use a decentl...