Oil lite bushing won't hold

DavidBarkey · Post by **DavidBarkey** » Mon Dec 18, 2023 12:50 pm

Eugen wrote: ↑Mon Dec 18, 2023 11:25 am I must not understand it well, as I thought between 20mm and 26mm there would be enough thickness for bronze bushing and steel sleeve.

The sintered bronze bushings are 20mm bore and 26mm od . Sintered does not take to machining well . Been there tried that before .

propane1 · Post by **propane1** » Mon Dec 18, 2023 1:17 pm

RoamingGnome wrote: ↑Mon Dec 18, 2023 12:01 pm
propane1 wrote: ↑Mon Dec 18, 2023 7:59 am
Neat stuff Gerry. Bet you buy that at princess auto. ?

Noel
Don't think so Noel... It's industrial stuff, smallest container is a 1-lb size and they just get bigger from there - I worked for a bunch of different heavy equipment manufacturers, CAT was the only one using Belzona, I've never seen it in a retail store.

Thanks Gerry. Sounds like great stuff. I guess it would be too expensive for a hobbyist I suppose. Big a large repair business could use it for sure.

Noel

RoamingGnome · Post by **RoamingGnome** » Mon Dec 18, 2023 2:01 pm

Yeah, sorry Noel... think all us little guys will have to settle for JB Weld - at least you can get it from Cdn Tire, Princess or Amazon...

Harry · Post by **Harry** » Mon Dec 18, 2023 7:57 pm

I’ve found JB at at lot of retailers here. NAPA and most auto parts stores. Lowes, Home Depot and even Walmart. I’ve found it to be a terrific product.

Harry

Colt Case Ingersoll Garden Tractors

Oil lite bushing won't hold

Re: Oil lite bushing won't hold

Re: Oil lite bushing won't hold

Re: Oil lite bushing won't hold

Re: Oil lite bushing won't hold