It's ground engaging time. Seeds, manure, soil, and everything that goes with them. But that's not all. Cutting and hauling wood, chainsaws and the works!
MattA wrote: ↑Wed Sep 22, 2021 9:45 pm
Anybody own a decent tow behind spreader?
I have a large Agri fab, I'd have to get the model off it. Works good, has pneumatic tires. I use it for food plots, don't fertilize my lawn.
You can borrow it if you bring it back.
I've got a Brinley BS36BH? Its #1 on this list but certainly has its issues. Mainly the flat bottom preventing all of the fertilizer from being dispensed and poor flow rate adjustability. At some point I may fab up a shield to prevent the fertilizer from being spread on my tractor and install a grate to help break up the fertilizer.
MattA wrote: ↑Wed Sep 22, 2021 9:45 pm
Anybody own a decent tow behind spreader?
I have a large Agri fab, I'd have to get the model off it. Works good, has pneumatic tires. I use it for food plots, don't fertilize my lawn.
You can borrow it if you bring it back.
I've got a Brinley BS36BH? Its #1 on this list but certainly has its issues. Mainly the flat bottom preventing all of the fertilizer from being dispensed and poor flow rate adjustability. At some point I may fab up a shield to prevent the fertilizer from being spread on my tractor and install a grate to help break up the fertilizer.
Mine is an older 125lb model. Should have a shield to not spread on the tractor. Was always stressing putting a bag of expensive, fine seed in and hoping you got the spread rate right.
deck's on, blades sharp, let's go it's time to mow
Tim I keep a log of my fertilizer settings for each type of fertilizer/lime/seed that I put down. Fertilizer is in the 1.5-2 setting. Lime and grass seed are in the 3-4 range. Not sure what the 4-10 range is for... maybe spreading salt in the winter? I'm thinking of modifying the mechanism so that setting 10 (wide open) is more like setting 5. The trouble I have is there is so little play in the settings at low rates for fertilizer that I typically get the application rate too low and have to cover the lawn again. I typically use a low rate and hit the lawn in two directions. This helps eliminate lawn striping from incorrect fertilizer application overlap.